P0810-56 Clutch Position Control Error - Invalid/incomplete configuration: Action
- Using the manufacturer approved diagnostic system, perform routine - Calibrate Clutch (401F) - To calibrate clutch
- Then, using the manufacturer approved diagnostic system, perform routine - Learn Clutch Open and Close Point for a minor calibration value change (408E) - 3 times to learn clutch open and close point for a minor calibration value changes
- After this, set torque request to 1000 Nm, using the manufacturer approved diagnostic system, perform routine - Lock Center Differential (4021) - To lock center differential. Clear DTC and retest
- If fault persists, check and install a new transfer case control module as required. Clear DTC and retest
- If fault persists, check and install a new transfer case as required