Remote Keyless Entry (RKE) Module: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This module is installed on the inside of the RH A-pillar above the footwell and does not change with the hand of drive.

Remove the cover and disconnect the battery ground cable. Refer to SPECIFICATIONS information.

CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.

Remove the RH side footwell trim panel.
- Remove the 3 clips.
Remove the keyless entry module.
- Remove the 2 Torx screws.
- Disconnect the 5 electrical connectors.