FixVault

Center Registers: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 Jaguar XFR, 2012 Jaguar XF, 2011 Jaguar XFR, 2011 Jaguar XF, and 2010 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not manually open the registers. Failure to follow this instruction may result in damage to the internal components.
NOTE: The center registers must be open before carrying out this procedure. To achieve this set the registers to 'Always Open' using the climate settings tab on the information and entertainment display. If the registers are set to 'Automatic' mode (rotating with ignition on/off) and one or more are disconnected during an ignition cycle, a vehicle battery reset may be required to reconnect the affected registers to the LIN BUS.
NOTE: Removal steps in this procedure may contain installation details.
  1. Set the registers to 'Always Open', using the information and entertainment display.
  2. See Passenger Side Register .
  3. Fully extend and lower the steering column for access.
  4. See figure.
    GJ0011066
  5. See figure.
    GJ0011031
  6. CAUTION: The center registers must be open to aid access and prevent damage to surrounding trim.
    CAUTION: Do not manually open the registers. Failure to follow this instruction may result in damage to the internal components.
  7. See figure.
    GJ0011070
  8. NOTE: Do not disassemble further if the component is removed for access only.
  9. See figure.
    GJ0011071