FixVault
Home › Jaguar › 2013 › XK Base, 2D Convertible › Repair and Diagnosis › External Pages › Different car › Section 3 (Supplemental Restraint System) › Supplemental Restraint System › Removal And Installation › Roll Over Protection Unit › Installation

Roll Over Protection Unit: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  2. Install the rear seat backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  3. Install the rear seat backrest trim panel.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Install the clips.
  4. Install the rear seat backrest. Refer to Rear Seat Backrest information.
  5. Connect the battery ground cable and install the cover. Refer to SPECIFICATIONS information.
  6. Connect WDS to the vehicle and configure a new module.
About FixVault