FixVault
Home › Jaguar › 2014 › XK Base, 2D Convertible › Repair and Diagnosis › Restraints › Restraints Control Systems › Supplemental Restraint System -- XK/X150 › Supplemental Restraint System › Rollover Protection Unit › Removal And Installation › Installation

Removal And Installation: Installation

  1. Install the roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  2. Install the rear seat backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  3. Install the rear seat backrest trim panel.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Install the clips.
  4. Install the rear seat backrest.

    For additional information, refer to: Rear Seat Backrest (Removal and Installation).

  5. Connect the battery ground cable and install the cover.

    For additional information, refer to: BATTERY, MOUNTING AND CABLES -- XK/X150 (Specifications).

  6. Connect WDS to the vehicle and configure a new module.
About FixVault