DTC B0005-13: Collapsible Steering Column Deployment Control - Circuit open: Action

WARNING: Do not measure the resistance of a deployable device using any other method than that described below.

NOTE: Steering column collapse actuator resistance specification is 1.70 ohms to 2.30 ohms at -40°C to 85°C.

Using the Jaguar Land Rover approved diagnostic equipment, check datalogger signal - Deployment Control 4 Resistance (0x5B07). Refer to the appropriate system wiring diagrams and check the steering column collapse actuator circuit for open circuit, high resistance
Disconnect the steering column collapse actuator connector and apply light pressure to the connector plunger. If the plunger moves to the engaged position the connector is damaged. Install a new wiring harness as necessary
Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new steering column collapse actuator