"Resume/ACCEL" Function

CAUTION: If engine is running, servo will move throttle to wide open position.

With ignition and control switch "ON", move control switch to "R/A" position, lamps 2, 3, 4, 5 and 6 should be on. Lamp 1 should be off. Lamp 4 will dim when servo moves throttle to wide open position, if engine is running.
If lamp 2 is off, check speed sensor continuity, check speed sensor terminals to Gray and Dark Blue wires, check terminals 2, 3, 5 and 7 (Gray, Dark Blue and Light Green wires are not grounded).
If lamp 3 is off, check brake light switch, check all Brown, Light Blue and Light Green wire connections. If lamp 4 is off, check terminals 2 and 11 at regulator connector, check continuity of throttle position feedback rheostat of servo.
If lamp 5 is off, check for bad connection at White (6) and Orange (12) wire terminals. If necessary, replace servo. If lamp 6 is off, check for bad connection at Red (4) or Orange (12) wire terminals. If necessary, replace defective servo.
If all lamps are off after moving control switch to "R/A" position, check for blown fuse or fuses, check Red, Pink, Brown or White wires for shorts. If necessary replace defective servo.