FixVault
Home › Jeep › 1994 › Wrangler S, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls - System/Component Tests › Engine Sensors & Switches › Crankshaft Position Sensor

Crankshaft Position Sensor

  1. Disconnect crankshaft position sensor. Connect ohmmeter across sensor terminal No. 2 (Black/Light Blue wire) and terminal No. 1 (Gray/Black wire).
  2. Ohmmeter should indicate an open circuit. Replace sensor if reading is not as specified. Also see appropriate crankshaft position sensor tests in TESTS W/CODES - 2.5L & 4.0L article in this section.
About FixVault