FixVault
Home › Jeep › 1995 › Grand Cherokee Laredo, 4.0 S, AWD › Repair and Diagnosis (Single Page) › Body & Frame › Door Locks › Anti-Theft System › Programming › Keyless Entry Transmitter

Keyless Entry Transmitter

  1. Open the driver's door of the vehicle. Leave the door open through the programming procedure.
  2. Move the mechanical door lock lever to the LOCK position.
  3. Turn the ignition switch to the ON position.
  4. Within 20 seconds, aim a transmitter at the keyless entry module receiver dome and press the LOCK button for at least 5 seconds. Once the module accepts the programming code, the driver's door will unlock.
  5. Once the first transmitter has be programmed, additional transmitters (up to 4 total) may be programmed into the module. Within 20 seconds of the previous transmitter programming, move the mechanical door lock lever to the LOCK position. Aim another transmitter at the receiver dome and press the LOCK button for at least 5 seconds. The door lock will cycle again.
  6. To lock the programmed codes into the module, the ignition switch must be turned OFF and back ON within 30 seconds after programming the last transmitter code. At this time, all previous codes are erased from the vehicle.
About FixVault