FixVault
Home › Jeep › 1995 › Wrangler SE, Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls - Tests W/Codes - 2.5L › Self-Diagnostic System › Entering On-Board Diagnostics › Scan Tool Diagnostic Mode

Scan Tool Diagnostic Mode

  1. Ensure ignition is off. Attach scan tool to data link connector. Connector is located on left side of engine compartment, near PCM. See Figure . Start engine (if possible). Turn A/C system on, then off (if equipped).
  2. Turn engine off. Without starting engine, turn ignition on and access READ TROUBLE CODES function of scan tool FUEL/IGN MENU.
  3. Record all fault messages displayed by scan tool, and observe MIL on instrument cluster. MIL should come on for 3 seconds and then go out (bulb check).
About FixVault