FixVault
Home › Jeep › 1996 › Cherokee Classic, Part Time, Standard › Repair and Diagnosis › External Pages › Different car › Section 29 (A/C-Heater System - Automatic) › Testing › Repairing DRB Blank Screen

Repairing DRB Blank Screen

WARNING: This page is about a different car, the 1995 Eagle Vision, 1995 Dodge Intrepid, 1995 Chrysler New Yorker, 1995 Chrysler LHS, and 1995 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
  1. If DRB screen is blank, turn ignition off and disconnect DRB from Data Link Connector (DLC). Using DVOM, measure voltage at DLC terminal No. 2 (Pink wire). If voltage is less than 10 volts, check fuse No. 13 and/or repair Pink wire circuit between battery and DLC. If voltage is greater than 10 volts, go to next step.
  2. Using DVOM, measure resistance between DLC terminal No. 6 (Black/Light Green wire) and ground. If resistance is greater than 20 ohms, repair open Black/Light Green wire ground circuit. If resistance is less than 20 ohms, go to next step.
  3. If DRB screen is still blank, substitute a different cable, cartridge or DRB until condition is corrected.
About FixVault