Test 11B - No Response From Radio

Turn ignition off. Disconnect radio Gray connector. Using scan tool in ohmmeter mode, measure resistance on terminal No. 6 (Red/Gray wire). If resistance is less than 5 ohms, repair Red/Gray wire for short to ground. Replace fuse No. 1. If resistance is 5 ohms or greater, replace radio. Replace fuse No. 1.

NOTE: For connector terminal identification, refer to CONNECTOR IDENTIFICATION . For wiring diagrams, refer to WIRING DIAGRAMS . After each repair, perform TEST VER-1A .

CAUTION: Always turn ignition off prior to disconnecting any module connector.