FixVault
Home › Jeep › 2000 › Cherokee Classic, 4D Utility, 4WD, Part Time › Repair and Diagnosis (Single Page) › Engine Performance › Remove, Overhaul & Install › Engine Controls - Removal, Overhaul & Installation › Computerized Engine Controls › Pcm Programming › Procedure For Programming PCM & Clearing DTCs From ABS & SRS Modules

Procedure For Programming PCM & Clearing DTCs From ABS & SRS Modules

  1. Connect scan tool to Data Link Connector (DLC). DLC is located below instrument panel near steering column. See Figure.
  2. Using scan tool, enter correct VIN and mileage into PCM. Using scan tool manufacturer's instructions, clear DTCs from ABS and SRS modules.
About FixVault