FixVault
Home › Jeep › 2003 › Grand Cherokee Overland › Repair and Diagnosis › Accessories & Equipment › Cruise Control Systems › Removal & Installation › Cruise Control Servo › Installation

Cruise Control Servo: Installation

  1. Position servo to mounting bracket.
  2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
  3. Insert servo mounting studs through holes in servo mounting bracket.
  4. Install servo cable mounting nuts and tighten to 75 INCH lbs. (8.5 N.m). If servo and bracket is being installed as one assembly, install 2 mounting nuts and tighten to 200-300 INCH lbs. (22-34 N.m).
  5. Connect vacuum line at servo.
  6. Connect electrical connector at servo.
  7. Connect servo cable to throttle body.
  8. Install battery tray and battery temperature sensor.
  9. Connect wiring to battery tray.
  10. Install battery to battery tray.
  11. Connect positive battery cable to Power Distribution Center (PDC).
  12. Connect positive battery cable to battery.
  13. Connect negative battery cable to battery.
  14. Before starting engine, operate accelerator pedal to check for any binding.
About FixVault