Map Sensor: Installation: 3.7L
WARNING: This page is about a different car, the 2004 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
The Manifold Absolute Pressure (MAP) sensor is mounted into the front of the intake manifold. An o-ring is used to seal the sensor to the intake manifold. See Figure.
- Clean MAP sensor mounting hole at intake manifold.
- Check MAP sensor o-ring seal for cuts or tears.
- Position sensor into manifold.
- Install MAP sensor mounting bolts (screws). Tighten screws to 3 N.m (25 in. lbs.) torque.
- Connect electrical connector.