VER-3 Test

Testing

1. Inspect the vehicle to ensure that all engine components are properly installed and connected.
2. Connect the DRBIII(R) to the Data Link Connector and erase the DTCs.
3. If the PCM was not replaced, skip steps  4 - 6 , then continue the verification.
4. If the PCM was replaced, the correct VIN and mileage must be programmed or a DTC will set in the ABS and airbag modules. If the vehicle is equipped with Sentry Key Immobilizer Module (SKIM), Secret Key data must be updated to enable start.
5. For ABS and airbag systems, enter correct VIN and Mileage in PCM. Erase codes in ABS and airbag modules.
6. For SKIM theft alarm: connect DRBIII(R) to data link connector. Go to Theft Alarm, SKIM, Misc. and place SKIM in secured access mode, by using the appropriate PIN code for this vehicle. Select update the Secret Key data. Data will be transferred from SKIM to PCM.
7. Perform the generator output test.
8. Start the engine and set the engine speed to 2000 RPM for at least 30 seconds. Allow the engine to return to idle.
9. Allow the engine to return to idle.
10. Cycle the ignition key off then on.
11. With the DRBIII(R), read DTCs. If there are any symptoms remaining, refer to DIAGNOSTIC TESTS  Check for any related TSB's. If no, test is complete.