Upshift Indicator Light

An upshift indicator is standard equipment on all instrument clusters, however on vehicles not built for the United States or Canadian markets and those not equipped with a manual transmission, this indicator is electronically disabled. The upshift indicator located near the right upper edge of the instrument cluster overlay, just above the oil pressure gauge. The upshift indicator consists of an upward pointed arrow icon that is a stencil-like cutout in the opaque layer of the instrument cluster overlay. The dark outer layer of the cluster overlay prevents the icon from being clearly visible when the lamp is not illuminated. An Amber lens behind the cutout in the opaque layer of the cluster overlay causes the icon to appear in Amber through the translucent outer layer of the overlay when it is illuminated from behind by a Light Emitting Diode (LED) soldered onto the instrument cluster electronic circuit board. When the exterior lighting is turned on, the illumination intensity of the part time indicator is one-step dimmable, which is adjusted using the panel lamps dimmer control ring on the left multifunction switch control talk. The upshift indicator is serviced as a unit with the instrument cluster

The upshift indicator gives an indication to the vehicle operator when the manual transmission should be shifted to the next highest gear in order to achieve the best fuel economy. This indicator is controlled by a transistor on the instrument cluster electronic circuit board based upon cluster programming end electronic messages received by the cluster from the Powertrain Control Module (PCM) over the Programrnable Communications Interface (PCI) data bus. The upshift indicator function of the instrument cluster is electronically enabled or disabled by a PCI data bus message received by the cluster from the PCM. The upshift indicator Light Emitting Diode (LED) receives battery current on the instrument cluster electronic circuit board through the fused ignition switch output (run-start) circuit whenever the ignition switch is in the On or Start positions. Therefore, the indicator will always be off when the ignition switch is in any position except On or Start. The LED only illuminates when it is provided a path to ground by the instrument cluster transistor. The instrument cluster will turn on the upshift indicator for the following reasons.

• Upshift Lamp-On Message
  
  Each time the cluster receives an upshift lamp-on message from the PCM indicating the engine speed and load conditions are right for a transmission upshift to occur, the upshift indicator is illuminated. The indicator remains illuminated until the cluster receives an upshift lamp-off message from the PCM or until the ignition switch is turned to the Off position, whichever occurs first. The PCM will normally, send an upshift lamp-off message 3 to 5 seconds after a lamp-on message, if an upshift is not performed. The indicator will then remain off until the vehicle stops accelerating and is brought back into the range of indicator operation, or until the transmission is shifted into another gear.
• Actuator Test
  
  Each time the cluster is put through the actuator test, the upshift indicator will be turned on, then off again during the bulb check portion of the test to confirm the functionality of the LED and the cluster control circuitry. The PCM continually monitors the engine speed and load conditions to determine the proper fuel and ignition requirements. The PCM then sends the proper upshift indicator messages to the instrument cluster. For further diagnosis of the upshift indicator or the instrument cluster circuitry that controls the indicator, see the appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT.