Crankshaft Position Sensor: Installation

Fig 1: CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALL

Courtesy of DAIMLERCHRYSLER CORP.

1 - RETAINING BOLT

2 - WASHER

3 - CRANKSHAFT POSITION (CKP) SENSOR

4 - ENGINE BLOCK

1. Lubricate o-ring on crankshaft position sensor and install sensor in engine block. See Fig 1.
2. Install crankshaft position sensor retaining bolt. See Fig 1. Torque bolt to 10.8N.m.(95 in.lbs.).
3. Connect crankshaft position sensor electrical connection.
4. Install the heat shield. Tighten fasteners to 10.8N.m.(95 in.lbs.).
5. Connect exhaust pipe to turbocharger downpipe. Torque bolts to 32.4N.m.(24 ft.lbs.).
6. Lower vehicle from hoist.
7. Connect negative battery cable.