FixVault
Home › Jeep › 2005 › Wrangler Rubicon, Standard › Repair and Diagnosis › Suspension › Wheel Alignment › Suspension System › Rear › Upper Control Arm › Installation

Upper Control Arm: Installation

  1. Position the upper suspension arm in the axle bracket and frame rail bracket.
  2. Install the bolts and finger tighten the nuts.
  3. Install the parking brake cable/bracket and ABS wiring bracket on the arm if equipped.
  4. Remove the supports and lower the vehicle.
  5. Tighten the upper suspension arm frame rail bracket bolt to 75 N.m (55 ft. lbs.).
  6. Tighten the upper suspension arm axle bracket nut to 75 N.m (55 ft. lbs.).
About FixVault