FixVault
Home › Jeep › 2006 › Commander Base, 3.7 K, AWD › Repair and Diagnosis › External Pages › Different car › Section 12 (Ignition System (Service Information)) › Glow Plug › Installation

Glow Plug: Installation

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean glow plug bay and install glow plug. Tighten glow plugs to 12 N.m (106 lbs. in.).
  2. Connect glow plug electrical connector (1).
  3. Install engine cover. (Refer to ENGINE - INSTALLATION) for 3.7L, (Refer to ENGINE - INSTALLATION) for 4.7L, (Refer to ENGINE - INSTALLATION) for 5.7L or (Refer to ENGINE - INSTALLATION) for 6.1L. .
  4. Connect negative battery cable.
About FixVault