Nag1 Automatic Transmission (Service Information): Clutch-Freewheeling: Assembly

Fig 1: Identifying Freewheeling Clutch F2

Courtesy of DAIMLERCHRYSLER CORP.

1 - HOLLOW SHAFT	4 - K3 INNER DISC CARRIER AND REAR PLANETARY SUN GEAR
2 - F2 CLUTCH SNAP-RING	5 - RETAINING RING
3 - FREEWHEELING CLUTCH F2	6 - O-RINGS

NOTE: The side of the freewheeling clutch F2 (3) with the markings (directional arrow, part number, etc.) must be up when the clutch is installed in the sun gear (4).

1. Press freewheeling clutch F2 (3) into sun gear (4). See Fig 1.
2. Install snap-ring (2) for freewheeling clutch.
3. Check O-rings (6) on hollow shaft, replace if necessary. See Fig 1.
4. Install rear sun gear (4) with K3 internally toothed disc carrier and rear freewheeling clutch (3) onto the hollow shaft.
5. Verify proper operation of the freewheeling clutch F2. When the assembly is held with the F2 clutch snap-ring upward, it should be possible to rotate the hollow shaft counter-clockwise.
6. Install retaining ring (5) onto hollow shaft (1).