Sensor-Accelerator Pedal Position: Installation
WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - HARNESS CONNECTOR |
| 2 - FASTENERS |
| 3 - ACCELERATOR PEDAL ASSEMBLY |
- Connect the accelerator pedal position sensor wiring harness connector (1) to the sensor. See Fig 1.
- Position the accelerator pedal assembly (3) and install the fasteners (2). See Fig 1.
- Install the drivers lower dash board close out panel.
- Connect the negative battery cable.