FixVault
Home › Jeep › 2006 › Wrangler X, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Engine & Automatic Transmission Cooling System › Engine › Engine Coolant Temperature Sensor › Installation

Engine Coolant Temperature Sensor: Installation

  1. Apply sealant to sensor threads (new replacement sensors will have sealant already applied).
  2. Install coolant temperature sensor into thermostat housing. Tighten to 11 N.m (8 ft. lbs.) torque.
  3. Connect wire connector.
  4. Fill cooling system. (Refer to COOLING - STANDARD PROCEDURE) .
About FixVault