Final Drive Control Module: Inputs/Outputs

The following are inputs to the FDCM:

1. Lateral Accelerometer
2. Transfer Case Range Select Switch
3. Transfer Case Mode Sensor Signal
4. 3 Direct Battery Feeds
5. Ignition RUN Sense
6. Sensor Grounds
7. Module Grounds
8. CAN C Bus

The following are outputs of the FDCM:

1. 5V Sensor Supply
2. Transfer Case NEUTRAL Lamp
3. Front Electronic Limited Slip Differential Pressure Solenoid
4. Rear Electronic Limited Slip Differential Pressure Solenoid
5. Transfer Case Bi-directional Motor Control (A & B)
6. Switched B+ Solenoid Supply
7. Transfer Case Motor Brake Control