FixVault
Home › Jeep › 2007 › Commander Overland, RWD › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Electronic Control Modules (Service Information) › Electronic Control Modules › Standard Procedure › SKREEM Programming › ECM/Skim/WCM Programming › Notes

ECM/Skim/WCM Programming: Notes

When a ECM and the SKIM are replaced at the same time perform the following steps in order:

  1. Program the new SKIM
  2. Program the new ECM
  3. Replace all ignition keys and program them to the new SKIM.

When an ECM (Bosch) and the SKIM are replaced at the same time perform the following steps in order:

  1. Program the new SKIM
  2. Program the new ECM (Bosch)
  3. Replace all ignition keys and program them to the new SKIM.
About FixVault