Steering Knuckle

Fig 1: Identifying Knuckle, Clevis Bracket And Bushing & Stabilizer Link

Courtesy of CHRYSLER LLC

1 - KNUCKLE

2 - CLEVIS BRACKET AND BUSHING

3 - STABILIZER LINK

Install the knuckle (1) to the vehicle.
Install the lower ball joint into the knuckle.
Install the lower ball joint nut. Tighten the nut to 95 N.m (70 ft. lbs.).

Fig 2: Removing/Installing Upper Ball Joint At Knuckle
Courtesy of CHRYSLER LLC
Install the upper ball joint (2) into the knuckle (3)

Install the upper ball joint nut (4). Tighten the nut to 95 N.m (70 ft. lbs.).

Fig 3: Identifying Knuckle, Clevis Bracket And Bushing & Stabilizer Link

Courtesy of CHRYSLER LLC

1 - KNUCKLE

2 - CLEVIS BRACKET AND BUSHING

3 - STABILIZER LINK

Install the outer tie rod end to the steering knuckle. Refer to INSTALLATION .

Fig 4: Removing/Installing Wheel Speed Sensor
Courtesy of CHRYSLER LLC
Install the hub/bearing (3), Tighten to 115 N.m (85 ft. lbs.). See INSTALLATION .
Install the axle shaft nut. Tighten the nut to 135 N.m (96 ft. lbs.) (if equipped with four wheel drive).
Install the wheel speed sensor (2) and reclip the wire to the knuckle. Refer to INSTALLATION .

Fig 5: Disc Brake Rotor Hub & O-Ring
Courtesy of CHRYSLER LLC

1 - ROTOR

2 - O-RING

Install the disc brake rotor (1). Refer to INSTALLATION .

Fig 6: Caliper Adapter

Courtesy of CHRYSLER LLC

1 - CALIPER ADAPTER

2 - KNUCKLE

3 - CALIPER ADAPTER BOLTS

4 - ROTOR