Lower Ball Joint: Installation

Fig 1: Installing Lower Ball Joint

Courtesy of CHRYSLER LLC

1 - C-4212-F PRESS

2 - 9654-2 RECEIVER

3 - LOWER CONTROL ARM

4 - BALL JOINT

5 - 9654-1 DRIVER

NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper operation during the removal and installation process.

1. Install the ball joint (4) into the control arm (3) and press in using special tools C-4212-F (press) (1), 9654-1 (Driver) (5) and 9654-2 (Receiver) (2).
2. Stake the ball joint flange in four evenly spaced places around the ball joint flange, using a chisel and hammer.
3. Remove the support for the halfshaft and install into position, then install the clevis bracket. 4X4 only  . See INSTALLATION .
4. Install the steering knuckle. See INSTALLATION .
5. Install the tie rod end into the steering knuckle. Refer to INSTALLATION .
6. Install and tighten the halfshaft nut to 251 N.m (185 ft. lbs.). (If Equipped).
7. Install the brake caliper and rotor. Refer to INSTALLATION .
8. Install the tire and wheel assembly. Refer to STANDARD PROCEDURE .
9. Check the vehicle ride height. See STANDARD PROCEDURE .
10. Perform a wheel alignment. See STANDARD PROCEDURE .