Bushings-Upper Control Arm

NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper operation during the removal and installation process.

Install the new upper control arm bushings into the upper control arm using tools 8830-3 (Adapter), 8830-1 (Driver) and 8830-2 (Receiver) the bearing with the threaded rod 8838 making sure to properly orient the bushing in the control arm. See Fig 1.
Remove the control arm from the vise.
Install the upper control arm. See INSTALLATION .
Perform a wheel alignment. See STANDARD PROCEDURE .

Fig 1: Installing Upper Control Arm Bushing

Courtesy of CHRYSLER LLC

1 - 8830-3 (ADAPTER)

2 - 8830-1 (DRIVER)

3 - BUSHING

4 - 8830-2 (RECEIVER)

5 - 8838 (THREADED ROD)