Front Toe

CAUTION: Do not twist the inner tie rod-to-steering gear rubber boots while turning the inner tie rods during the front toe adjustment.

NOTE: Perform the following at each front wheel as necessary.

Fig 1: Tie Rod Jam Nut

Courtesy of CHRYSLER LLC

Loosen the tie rod adjusting jam nut (1). Grasp the inner tie rod (3) and rotate it one way or the other until the front wheel toe is set to the preferred specification. See SPECIFICATIONS .
Tighten the tie rod adjusting jam nut to of 75 N.m (55 ft. lbs.).
Make sure the inner tie rod-to-steering gear rubber boot is not twisted.
Remove the steering wheel clamp.
Remove the alignment equipment.
Road test the vehicle to verify the steering wheel is straight and the vehicle does not pull or wander.