FixVault
Home › Jeep › 2008 › Liberty Limited, 4WD, Part Time › Repair and Diagnosis › Suspension › Wheel Alignment › Suspension System › Front › Upper Control Arm › Installation › Upper Control Arm - Right

Upper Control Arm - Right

  1. Install the upper control arm to the vehicle.
  2. Install the upper control arm front flag bolt. Tighten the nut to 122 N.m (90 ft. lbs.) with full vehicle weight. 
  3. Install the upper control arm rear flag bolt. Tighten the nut to 122 N.m (90 ft. lbs.) with full vehicle weight. 
  4. Install the air box. Refer to INSTALLATION .
  5. Install the upper ball joint nut. Tighten the nut to 41 N.m (30 ft. lbs.) plus an additional 90° turn.
  6. Install the right side tire and wheel assembly. Refer to STANDARD PROCEDURE .
  7. Lower the vehicle.
  8. Set the toe. See STANDARD PROCEDURE .
About FixVault