FixVault
Home › Jeep › 2008 › Liberty Limited, RWD › Repair and Diagnosis (Single Page) › Electrical › Body Electrical › Power Distribution (Service Information) › Power Distribution › Module-Totally Integrated Power › Removal › Power Distribution Center

Power Distribution Center

Fig 1: TIPM Positive Cable Retaining Nut, Cable, Mounting Stud & Totally Integrated Power Module (TIPM) Cover
GC0061400Courtesy of CHRYSLER LLC
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
  3. Open the Totally Integrated Power Module (TIPM) cover (4).
  4. Remove the TIPM positive cable retaining nut (1) and remove the cable (2) from the mounting stud (3).
    Fig 2: Identifying Integrated Power Module (TIPM), TIPM Mounting Bracket & Mounting Tabs
    GC0061405Courtesy of CHRYSLER LLC
  5. Using an appropriate flat bladed tool, depress the four mounting clips to disengage and remove the TIPM housing (1) from the TIPM bracket mounting tabs (3).
    Fig 3: Disconnecting/Connecting TIPM Wire Harness Connectors
    GC0061406Courtesy of CHRYSLER LLC
  6. Disconnect each of the seven TIPM wire harness connectors from the TIPM housing (2).
  7. Remove the TIPM from the vehicle.
About FixVault