SENSOR, Camshaft Position: Installation: Rear

Fig 1: Removing/Installing Camshaft Position Sensor

Courtesy of CHRYSLER LLC

1. Lubricate sensor o-ring.
2. Install sensor utilizing twisting motion. Make sure sensor is fully seated. Do not drive sensor into the bore with screw. This can cause sensor to be incorrectly seated causing engine to fail.
3. Install mounting bolt and tighten to 9 N.m (79.5 in. lbs.).
   Fig 2: Identifying Camshaft Position Sensor Heat Shield - Remove/Install

   Courtesy of CHRYSLER LLC
4. Carefully attach electrical connector to camshaft position sensor. Feel for positive lock (click). Installation at angle may damage the sensor pins.
5. Install heat shield onto mounting stud.
6. Install heat shield retaining nut and tighten.
   Fig 3: Identifying Camshaft Position Sensor Heat Shield - Remove/Install

   Courtesy of CHRYSLER LLC
7. Connect negative battery cable.