Diagnostic Test

REPLACE OCCUPANT RESTRAINT CONTROLLER
1. Turn the ignition on.
  WARNING:
  Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  
  WARNING:
  If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take proper precautions could result in accidental airbag deployment and serious or fatal injury.
  
  With the scan tool, read the ORC DTCs.
  
  Does the scan tool display B1BCF-ROLL OVER SENSOR DTC?
  
  Repair
  - Replace the Occupant Restraint Controller in accordance with the Service Information.
  - Perform the AIRBAG SYSTEM VERIFICATION TEST procedure. Refer to Standard Procedure .