FixVault
Home › Jeep › 2011 › Wrangler Sahara, Standard › Repair and Diagnosis › External Pages › Different car › Section 91 (Electronic Control Modules (Service Information)) › Module, Telematics Gateway › Installation › Installation

Module, Telematics Gateway: Installation: Installation

WARNING: This page is about a different car, the 2011 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Antenna(s), Video Cable, RF HUB, Wiring Connectors And UCI Cables
GC0144027Courtesy of CHRYSLER LLC
  1. Connect the antenna(s) (1), Hands Free Module (HFM) and UCI cables (4), video cable (3) and wiring connectors (2) to the Telematics Gateway Module (TGM).
  2. Position the TGM into the mounting location.
    Fig 2: Retainers & Telematics Gateway Module (TGM)
    GC0147702Courtesy of CHRYSLER LLC
  3. Install the retainers (1) to the TGM.
    Fig 3: Bezel Assembly
    GC0147717Courtesy of CHRYSLER LLC
  4. Install the switch bank assembly. Refer to POD, SWITCH BANK, INSTALLATION .
  5. Connect the negative battery cable.
  6. Restore user data from backup. Refer to STANDARD PROCEDURE .
About FixVault