FixVault
Home › Jeep › 2012 › Compass Latitude, 2.4 B, AWD, Automatic CVT, CVT2 › Repair and Diagnosis › External Pages › Different car › Section 489 (Electronic Control Modules (Service Information)) › Module, Vehicle System Interface › Removal › Removal

Module, Vehicle System Interface: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel end cap. Refer to CAP, INSTRUMENT PANEL END, REMOVAL .
  2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
  3. Disconnect and isolate the negative battery cable.
    Fig 1: Vehicle System Interface Module Connectors
    GC0170605Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect all electrical connectors from the Vehicle System Interface Module (VSIM).
    Fig 2: Vehicle System Interface Module Tab
    GC0170633Courtesy of CHRYSLER GROUP, LLC
  5. Depress the tab at the bottom of the VSIM. This will release the lower portion of the VSIM from the VSIM bracket.
  6. Pull the VSIM down and at an angle to release the upper guide tab from the VSIM bracket.
  7. Remove the VSIM from the vehicle.
About FixVault