FixVault
Home › Jeep › 2012 › Compass Latitude, 2.4 B, AWD, Automatic CVT, CVT2L › Repair and Diagnosis › External Pages › Different car › Section 489 (Electronic Control Modules (Service Information)) › Module, Power Sunroof › Removal › Removal

Module, Power Sunroof: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Do not attempt to move or reposition the sunroof glass panel or drive cables with the sunroof motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.

WARNING:

The Sunroof Motor And Module Initialization procedure must be completed any time a sunroof motor and module unit is replaced with a new component. Failure to perform this procedure may result in damage to the vehicle, to the sunroof or in serious or fatal injuries.

Fig 1: Motor And Module Unit Connector & Screws
GC0170663Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Lower the front of the headliner to gain access to the module unit. Refer to HEADLINER, REMOVAL .
  3. Remove the three screws (1) that secure the motor and module to the sunroof frame.
  4. Lower the motor and module unit far enough to access and disconnect the sunroof wire harness connector (2).
  5. Remove the sunroof motor and module unit from the vehicle.
About FixVault