FixVault
Home › Jeep › 2012 › Compass Latitude, 2.4 B, AWD, Automatic CVT, CVT2L › Repair and Diagnosis › External Pages › Different car › Section 489 (Electronic Control Modules (Service Information)) › Module, Vehicle System Interface › Installation › Installation

Module, Vehicle System Interface: Installation: Installation

WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Vehicle System Interface Module Bracket & Upper Guide
GC0170780Courtesy of CHRYSLER GROUP, LLC
  1. Position the Vehicle System Interface Module (VSIM) to the bracket with the upper guide (2) aligned with the VSIM bracket opening.
    Fig 2: Slot Opening
    GC0170627Courtesy of CHRYSLER GROUP, LLC
  2. Engage the upper VSIM guide to the slot opening (1) located at the top of the VSIM bracket.
    Fig 3: Vehicle System Interface Module Tab
    GC0170633Courtesy of CHRYSLER GROUP, LLC
  3. Seat the lower portion of the VSIM to the bracket and press inward until the lower guide (1) snaps into position.
    Fig 4: Vehicle System Interface Module Connectors
    GC0170605Courtesy of CHRYSLER GROUP, LLC
  4. Connect all relevant wiring harness connections to the VSIM.
  5. Install the instrument panel end cap. Refer to CAP, INSTRUMENT PANEL END, INSTALLATION .
  6. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
  7. Connect the negative battery cable.
About FixVault