SENSOR, Intrusion Module: Removal: Receiver
WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Remove the overhead console from the headliner. Refer to Electrical/Overhead Console - Removal .
- Locate the intrusion sensor receiver (1) in the mounting bracket (4) on the right front corner of the overhead console housing (3).
- Disconnect the take out of the overhead wire harness from the connector receptacle (5) on the rearward end of the receiver housing.
- Release the three latch features (2) of the mounting bracket and disengage the receiver from the bracket.