FixVault
Home › Jeep › 2012 › Compass Limited, AWD, Standard › Repair and Diagnosis › External Pages › Different car › Section 380 (Electronic Control Modules (Service Information)) › Module, Power Sunroof › Module Programming › Sunroof Motor And Module Initialization › Dual Pane Sunroof › Sunshade

Dual Pane Sunroof: Sunshade

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the ON position.
  2. Depress and hold the CLOSE push button of the sunroof switch until the sliding sunshade panel has moved to the fully closed position.
  3. Be certain that the sunroof sliding glass panel is in the fully closed position before finishing the sunshade motor and module initialization.
  4. Depress the OPEN push button of the sunshade switch and release. The sunshade panel should travel to the mid-open position at least beyond the back of the sliding glass panel opening.
  5. Depress the OPEN push button of the sunshade switch again and release. The sunshade panel should travel to the fully opened position.
  6. Depress the CLOSE push button of the sunshade switch and release. The sunshade panel should travel to the fully closed position.
  7. Repeat Steps 4 through 6 for at least 5 complete sunshade panel cycles (MID-OPEN, FULL-OPEN, CLOSE).
About FixVault