FixVault

UCONNECT Access

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

A Uconnect™ Access system is factory-installed optional equipment that uses an embedded cellular module within the Radio Receiver Module (RRM) (also known as the radio or the head unit) to enable several mobile connectivity features. Vehicles equipped with the Uconnect™ Access system can be readily identified by two switch buttons on the inside rear view mirror identified with ASSIST  and 9-1-1  labels.

To enable Uconnect™ Access, a subscription must be completed by the customer. Detailed directions for subscription along with other information relating to Uconnect™ Access can be found on www.driveuconnect.com  or within the Uconnect™ owner manual supplement for the supported radios.

NOTE:

A free trial period of Uconnect™ Access may be offered with the sale of a new vehicle. Registration will be required to activate the trial subscription.

Subscription to Uconnect™ Access provides many features that allow cellular smart phones to be put away in favor of the integrated mobile connectivity features and functionality accessible through the use of the radio, steering wheel and voice controls in the vehicle. All Access features are only available based on subscription. Features are continually being added or changed and offerings at the time this information was last updated included:

Refer to www.driveuconnect.com  for the latest information and helpful videos describing all of the Uconnect™ services and offerings.

The Uconnect™ Access system includes the following major components, which are described in further detail elsewhere in this service information:

The RRM contains a microcontroller and programming that allows it to communicate with other electronic modules in the vehicle over the Controller Area Network - Interior High Speed (CAN-IHS) data bus. In vehicles equipped with Uconnect™ Access, the RRM also uses electronic message communication with other electronic modules in the vehicle over the CAN-C data bus. Refer to COMMUNICATION, DESCRIPTION .

The Uconnect™ Access system components cannot be adjusted or repaired. If any Uconnect™ Access system component is damaged or ineffective, that component must be replaced. The external combination antenna can be repaired separately from the RRM. The Uconnect™ Access system software is flash programmable through the Universal Serial Bus (USB) port.