FixVault
Home › Jeep › 2012 › Compass Limited, AWD, Standard › Repair and Diagnosis › External Pages › Different car › Section 708 (3.6L Engine (Service Information)) › Engine Mounting › Insulator, Engine Mount, Left › Installation

Insulator, Engine Mount, Left: Installation

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0144622Courtesy of CHRYSLER GROUP, LLC
  1. If removed, position the left engine mount bracket, install the four retaining bolts and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  2. Install the left engine mount isolator (2) onto the bracket and tighten the retaining nuts (1) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Lower the screw jack until both engine mount isolators are in position.
    GC0144614Courtesy of CHRYSLER GROUP, LLC
  4. Lower the engine so the weight is resting on the isolators and remove the screw jack.
  5. Install both left and right engine mount isolator to frame bolts (2) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  6. Install the belly pan and retainers (1).
    GC0095584Courtesy of CHRYSLER GROUP, LLC
  7. Remove support and lower the vehicle.
    GC0144614Courtesy of CHRYSLER GROUP, LLC
  8. Position the engine mount isolator heat shields (4), install the retaining nuts (3) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0144029Courtesy of CHRYSLER GROUP, LLC
  9. Position the air inlet hose assembly (5) onto the throttle body and the air cleaner housing.
  10. Secure the air inlet hose assembly retaining grommet onto the ball stud (4).
  11. Tighten the clamp at the air cleaner housing (3) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  12. Tighten the clamp (2) at the throttle body to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  13. Connect the Inlet Air Temperature (IAT) sensor wire harness connector (1).
    GC0144028Courtesy of CHRYSLER GROUP, LLC
  14. Install the engine cover (1).
  15. Connect the negative battery cable.
About FixVault