Module, Radio Antenna: Removal: Module
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
- Remove the trim from the upper right C-pillar (1). Refer to PANEL, C-PILLAR TRIM, REMOVAL .
- Disconnect the wire harness connector (4) from the antenna module (2).
- Remove the fastener (3) that secures the antenna module to the C-pillar.
- Disengage the mounting tab of the antenna module from the slotted hole in the C-pillar and remove the module from the vehicle.