Pedal, Accelerator: Installation: Installation

WARNING: This page is about a different car, the 2016 Dodge Charger and 2015 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.

The Accelerator Pedal Position Sensor (APPS) and the accelerator pedal is serviced as a complete assembly including the bracket.

Fig 1: Accelerator Pedal Assembly With APPS

Courtesy of CHRYSLER GROUP, LLC

Install the accelerator pedal assembly on the two mounting studs (1). Tighten nuts (4) to the proper specification. Refer to FUEL INJECTION, GAS, SPECIFICATIONS .
Connect the APPS (6) wire harness connector (3).
Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
Connect the negative battery cable.
Use a scan tool to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
If necessary, also use a scan tool to erase any Diagnostic Trouble Codes (DTC's) from the PCM.
Before starting the engine, operate the accelerator pedal to check for any binding.