Section 198 (Steering System): Pump: Installation: 2.8L-Diesel

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Mounting Bolts

Courtesy of CHRYSLER GROUP, LLC

Install the pump to the vehicle.
Install the three bolts (2) securing the pump (1) to the engine and tighten to 47 N.m (35 ft. lbs.).

Fig 2: Removing/Installing Steering Pump - 2.8L
Courtesy of CHRYSLER GROUP, LLC
Install the power steering hoses (1, 6). Tighten to 28 N.m (21 ft. lbs.).
Install the power steering pulley to the pump.
Install the three bolts (4) securing the pulley (3) to the pump (2).
Install the serpentine belt.

Fig 3: Turbo Air Inlet Tube
Courtesy of CHRYSLER GROUP, LLC
Install the air inlet tube (1).
Install the air cleaner box.
Refill the power steering fluid and bleed the system. Refer to STANDARD PROCEDURE .