FixVault
Home › Jeep › 2012 › Wrangler Sahara, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 213 (Fuel System) › Fuel Injection, Diesel › Sensor, Air Temperature, Intake › Installation › Installation

Sensor, Air Temperature, Intake: Installation: Installation

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: IAT/MAP Sensor Harness Connector, Bolt & IAT/MAP Sensor
GC0148204Courtesy of CHRYSLER GROUP, LLC
  1. Inspect and lubricate the sensor O-ring.
  2. Clean IAT/MAP sensor sealing area.
  3. Install IAT/MAP sensor (1) and securely tighten bolt (2).
  4. Connect the IAT/MAP sensor harness connector (3).
  5. Connect the negative battery cable.
About FixVault