Damper, Steering: Removal: Bracket

NOTE:

Some early built right hand drive vehicles may have a damper with the mounting stud on the damper instead of on the bracket. If the mounting stud is on the damper, the damper and link bracket must be replaced as a kit, and the replacement damper will be different.

NOTE:

Left hand drive shown in illustration, right hand drive similar.

Fig 1: Steering Damper & Link Bracket

Courtesy of CHRYSLER GROUP, LLC

Place the front wheels in a straight ahead position.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the damper (2). Refer to DAMPER, STEERING, REMOVAL .
Remove the nut and bolt (5) from the linkage bracket (4).
NOTE:
It may be necessary to spread the bracket to fit over the tube.
Slide the bracket (4) to the tie rod tube end and remove from tie rod tube.