FixVault
Home › Jeep › 2012 › Wrangler Sahara, Standard Trans › Repair and Diagnosis › Suspension › Wheel Alignment › Front Suspension & Wheel Alignment › Front › Link, Stabilizer Bar › Installation › Installation

Link, Stabilizer Bar: Installation: Installation

Fig 1: Identifying Stabilizer Link (Right) Components
GC0130328Courtesy of CHRYSLER GROUP, LLC
NOTE:

Stabilizer bar link to axle bolt should be tightened with vehicle sitting on its tires

  1. Install the stabilizer link (1) to the vehicle.
  2. Install the right lower stabilizer bar link bolt (4) to the axle. Tighten to 102 N.m (75 ft. lbs.).
  3. Install the right upper stabilizer bar link nut (2) to the stabilizer bar. Tighten to 102 N.m (75 ft. lbs.).
    Fig 2: Identifying Stabilizer Link (Left) Components
    GC0130319Courtesy of CHRYSLER GROUP, LLC
  4. Install the left lower stabilizer bar link bolt (4) to the axle. Tighten to 102 N.m (75 ft. lbs.).
  5. Install the left upper stabilizer bar link nut (1) to the stabilizer bar. Tighten to 102 N.m (75 ft. lbs.).
  6. Remove the support and lower the vehicle.
About FixVault