FixVault
Home › Jeep › 2013 › Compass Limited, FWD › Repair and Diagnosis › External Pages › Different car › Section 78 (Rear Driveline Module) › Seal, Output Flange › Installation › Installation

Seal, Output Flange: Installation: Installation

WARNING: This page is about a different car, the 2012 Jeep Patriot and 2012 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seal Onto Installer
GC0083901Courtesy of CHRYSLER GROUP, LLC
  1. Place the seal on the installer.
    Fig 2: Install Pinion Side Seal
    GC0083902Courtesy of CHRYSLER GROUP, LLC
  2. Install the pinion side seal using Installer (special tool #9893, Installer, Seal) and Handle (special tool #C-4171, Driver Handle, Universal).
  3. Install right side halfshaft. Refer to INSTALLATION or INSTALLATION or INSTALLATION .
    Fig 3: Seal Onto Installer
    GC0083901Courtesy of CHRYSLER GROUP, LLC
  4. Place the seal on the installer.
    Fig 4: Install Ring Gear Side Seal
    GC0083903Courtesy of CHRYSLER GROUP, LLC
  5. Install the ring gear side seal using Installer (special tool #9893, Installer, Seal) and Handle (special tool #C-4171, Driver Handle, Universal).
  6. Install left side halfshaft. Refer to INSTALLATION or INSTALLATION or INSTALLATION .
  7. Fill RDA as needed. Refer to STANDARD PROCEDURE .
  8. Lower vehicle and road test.
About FixVault