Drive Plate Misalignment

WARNING: This page is about a different variant/trim than selected.

Common causes of misalignment are:

Heat warping
Mounting drive plate on a dirty crankshaft flange
Incorrect bolt tightening
Improper seating on the crankshaft shoulder
Loose crankshaft bolts

Clean the crankshaft flange before mounting the drive plate. Dirt and grease on the flange surface may misalignment the flywheel, causing excessive runout. Use new bolts when mounting drive plate to crankshaft. Tighten drive plate bolts to specified torque only. Over-tightening can distort the drive plate hub causing excessive runout.