2.0L Diesel

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the engine cover. .

Fig 1: Cooling Fan Module & Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the cooling fan module harness connector (1).

Fig 2: MAF Sensor Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Remove the breather hose (2) from breather tube.
Disconnect the Closed Crankcase Ventilation (CCV) heater wire harness connector (4).

Fig 3: Turbocharger Inlet Hose & Clamp
Courtesy of CHRYSLER GROUP, LLC
Loosen clamps (4, 6) and remove the turbocharger inlet tube (5).
Remove the bolts that secure the cooling fan assembly to the radiator.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the belly pan. Refer to BELLY PAN, REMOVAL .

Fig 4: Left Charge Air Cooler (CAC) & Hose
Courtesy of CHRYSLER GROUP, LLC
Disconnect the left Charge air Cooler (CAC) hose (1) from cooler (2).

Fig 5: CAC Tube-To-Engine Nut
Courtesy of CHRYSLER GROUP, LLC
Remove nut (1) securing CAC tube (2) to engine.
Remove the support and lower the vehicle.

Fig 6: EGR Air Flow Control Valve Inlet Tube, CAC Tube Wire Retainer & CAC Hose
Courtesy of CHRYSLER GROUP, LLC
Unlock CAC tube wire retainer (2).
Separate the CAC hose (3) at from EGR air flow control valve inlet tube (1).
Raise the vehicle.
Using care, lift the fan slightly upward.

Fig 7: Cooling Fan Assembly
Courtesy of CHRYSLER GROUP, LLC
Tilt the cooling fan down to allow for the upper mounting tab to clear the upper radiator hose.
Remove the fan assembly from the vehicle.